Select Adobe Audition > Settings > Playback and Recording .
Last updated on
Mar 28, 2023
Learn how to monitor recording and playback levels in Adobe Audition to maintain optimal audio quality and avoid distortion.
To monitor the amplitude of incoming and outgoing signals during recording and playback, you use level meters. The Waveform editor provides these meters only in the Levels panel. The Multitrack editor provides them in both the Levels panel, which shows the amplitude of the mix output, and track meters, which show the amplitude of individual tracks.
You can dock the Levels panel horizontally or vertically. When the panel is docked horizontally, the upper meter represents the left channel, and the lower meter represents the right channel.
Note
To show or hide the panel, choose Window > Level Meters.
The meters show signal levels in dBFS (decibels below full scale), where a level of 0 dB is the maximum amplitude possible before clipping occurs. Yellow peak indicators remain for 1.5 seconds so you can easily determine peak amplitude.
If amplitude is too low, sound quality is reduced; if amplitude is too high, clipping occurs, and produces distortion. The red clip‑indicator to the right of the meters lights up when levels exceed the maximum of 0 dB.
Note
To clear clip indicators, either click them individually or right-click the meters and choose Reset indicators.
Effects Rack Input/ Output monitor
In the Effects Rack, the two-level meters display the signal level of the Input (the clips and tracks being routed through those effects) and the Output (the signal level leaving the effects chain).
Much effect will have some impact on the overall level of the signal, either amplifying it or reducing it. By seeing the levels, you can adjust the knobs next to each to fine-tune the amount of signal going into the effects (which can have impact on how the sounds are processed) or exiting the effect (making sure that the effects aren't clipping or are loud enough to be audible).
Play your audio at a custom speed of 1.1x, 1.2x, etc. Use JKL Shuttle Speed to adjust the customized playback speed.
Select the JKL Shuttle Speed to set the desired speed. Choose from Slow Speed (0.1X), Half Speed (0.5x), Normal Speed (1x), and Double Speed (2x).
To set customized playback speed, select any desired increment from the JKL Shuttle Speed panel, play the audio, and press the l key the times to achieve the required speed. You can check the Display speed of playback in the playback control.
Customize level meters
Right-click the meters and select any of the following options:
Meter Input Signal
The Waveform editor displays the default hardware input level. To quickly enable or disable this option, double‑click the meters.
Range options
Change the displayed decibel range.
Show Valleys
Shows valley indicators at low-amplitude points. If valley indicators are close to peak indicators, the dynamic range (the difference between the quietest and loudest sounds) is low. If the indicators are widely spaced, the dynamic range is high.
Show Color Gradient
Gradually transitions the meters from green, to yellow, to red. Deselect this option to display abrupt color shifts to yellow at -18 dBFS, and red at -6.
Show LED Meters
Displays a separate bar for each whole decibel level.
Dynamic or Static Peaks
Change the mode of peak indicators. Dynamic peaks resets the yellow peak level indicators to a new peak level after 1.5 seconds, letting you easily see recent peak amplitude. As the audio gets quieter, the peak indicators recede. Static peaks retains peak indicators, letting you determine the maximum amplitude of the signal since monitoring, playback, or recording began. However, you can manually reset peak indicators by clicking clip indicators.
Tip: To find out how loud audio will get before you record it, choose Static peaks. Then monitor input levels; the peak indicators show the level of the loudest part.
Edit, mix, and record with Audition
Create and edit audio for podcasts, music, film, and more.
